Geeetech

So u dont wanna help me if i send the source?

Ok.
For you what it's my problem?

I enable in config.h

//#define FILAMENT_WIDTH_SENSOR that's not even the same thing that's to check the size. i tried every firmware offer here and official before i was like there all garbage and made a decent firmware. if you don't want to listen to people that know what there doing and have spent 100s of hours testi...

vert wrote: ↑

Mon Dec 17, 2018 2:50 am

zonalimitatore wrote: ↑

Mon Dec 17, 2018 2:49 am

vert wrote: ↑

Mon Dec 17, 2018 2:46 am

did you add g29 to your slicer to do auto bed levelling?

Yes,but I have no control on LCD menu,and I cannot do a Z home,cause don't detect when probe touch the bed,and continue fall down

sounds like firmware is written wrong.

I'm not the only one have this problem

vert wrote: ↑

Mon Dec 17, 2018 2:47 am

zonalimitatore wrote: ↑

Mon Dec 17, 2018 2:45 am

I've write my own firmware,and I haven't filament sensor enable.

what the entire 4 lines it takes to control the bltouch?

//#define FILAMENT_WIDTH_SENSOR

vert wrote: ↑

Mon Dec 17, 2018 2:46 am

did you add g29 to your slicer to do auto bed levelling?

Yes,but I have no control on LCD menu,and I cannot do a Z home,cause don't detect when probe touch the bed,and continue fall down

I've write my own firmware,and I haven't filament sensor enable.

Mount....follow how install,add parameters to firmware,reflash,aaaaaaaand.....not work. No control in menu

Geeeeeeetech....there is a way to make it work or it's lost time?

I try to wire like in photo above. When start the printer,the 3d touch do up&down 2 times ,and stay up with red led on. The problem is: I have no control on it In the menu if i click autotest,no moves,and the same on other commands I try to do z home,but doesn't stop,and signed my bed :evil: It's my...

Wolle82 wrote: ↑

Fri Sep 21, 2018 6:54 pm

Here is a picture of correct wireing:
3d_touch_a10.jpg

Have fun!

So...i have rev.b of first versione of a10.
Are you sure if i follow the image i have 3d touch work?
Thanks