Geeetech

Hello i have mesured the voltage here... there is no voltage and the corresponding lead is not glowing when i put the heat bed to heat. i think thats the problem , but i dont know how to fix it ... i mesured the resistence of the heat bed too 992Ω 992Ω and 991Ω I have an other problem, the Z axis c...

hot end fan (pwn-fan) is controled by g-code.so it's running according to the code.

rxn123talon wrote:The fan is connected per instructions for G2S -- Connect fan for hot end at FAN-PWM.

hi,pwm fan is controled by g-code.

Hi people, I have the G2S Rostock kit, which is now assembled per the instructions. When trying to set up the printer, I have downloaded the firmware and uploaded this to the controller ( http://www.geeetech.com/wiki/index.php/Delta_Rostock_mini_G2#How_to_modify_and_upload_firmware) . I have set up...

Following http://www.soonwell.com/ebay_file/App_pic/i35_21 Im on step 7.2, assembling the X-Axis Rods and ends. The screw locking fender that is supposed to be screwed down tight to the smooth rod has no set screws. Are there supposed to be some, am I supposed to use something else, or are they not...

Hi Can you please send me the firmware for the Prusi I3 X with the single motherboard GT2560 . The board you sent with my order does not recognise the display , flashed new Marlin firmware however the printer is not working correctly , eg does not respond to the limit switch activation Thanks hi, s...

view these coordinates,it seems that the auto-level is not successful.and maybe the hotbed is a little inclined.so please adjust the hot bed plane. then,you need to define z final axis height.those coordinate shows that the around point is higher than center.so you'd better adjust z axis height. mor...

hi,could you tell me your printer type?
if it is I3 PRUSA,those endstop wires should be connected x-min ,y-min ,z -min slot.
and there is no difference of Fan 1, Fan 2 and Fan 3 .but pwm fan is for turbofan which is used to cool nozzle.

hello,shiva.your z axis appears to not move smothly.you can try to adjust those screws of 2 z-axis.it seems that the z axises are getting a little stuck.

And also what do you mean by the Y driver board? You mean to swap the Y connector with X connector for example or to swap the servo motor? hi,Y driver board is stepper driver(A4988).Did you check your endstop?for example,you can swap x endstop with y.if y could home normally,that it's the endstop p...