Geeetech

Tomyuan wrote: ↑

Thu Apr 25, 2019 1:57 pm

If you want to calibrate your estep.
Refer to this vid：
https://www.youtube.com/watch?v=X3A9Ir2SreI

My estep is 457

Thanks, I will check.

My current value is 340, AFAIK.

Tomyuan wrote: ↑

Thu Apr 25, 2019 1:42 pm

Hi,BR365


I am using the PETG for my A20M.
You can change the temp of the bed+temp of the hotend.
Then the others settings same as my PLA setting

Thanks,
and could You tell me Your value for Esteps/mm?

Moritz

Tomyuan wrote: ↑

Thu Apr 25, 2019 9:24 am

Maybe mine's is not perfect.
But you can have a try:
Geeetech A20M.zip

This one is for ABS, isn't it?

Maybe interesting would be the E-Step value of Your setup. Maybe, my value isn't perfect. I didn't check yet.

Greetings
Moritz

Does the extruder working temperature achieve Preset temperature？ Hello William, I don't have a thermometer, therefore, I didn't check this. The Dog was printed with 205°C: https://modellbauhuette.dettenbachtal.de/wp-content/uploads/2019/04/IMG_20190424_142522_01-644x486.jpg This looks very good, I...

Thanks, Tomyuan, I will post my profile tonight. It base on the Slic3r Bundle Config from Jarda3D (http://www.geeetech.com/forum/viewtopic.php?f=67&t=62527), I only changed the size of the printer bed. The following one (double lenght compared to the above one) was done with Retraction of 4 mm and 1...

Small Benchy, the layers and edges look quite perfect, but there are so much bubbles and threads, I don't know why:

Hello, I'm looking for profiles for the A20M to be used with Repetier Host and the Slic3r software. The print of the test Dog is quite well but my own parts I tested were underextruded. So I increased extrudion to 120% and later to 150%, but it didn't help. Or should I try a slower speed? Is there a...

Hello,
here is a short report about my first experiences with the A20M: https://modellbauhuette.dettenbachtal.d ... stbericht/



Will be continued!

Moritz

OK, so I have to compile my own firmware?

Thanks. I will wait for the replacement part, as I heard the drive gear extruders are better then the standard ones.

Hello, I have a A20M but I had to use a different Filament drive for E0. But, because the original gear uses a different E-Step (different gear) as the replaced one, I need to use different E-Steps for E0 and E1. In the display interface, there is only one E-Step for E0 and E1 together. Is there a n...