Search found 329 matches

by Gingko
Thu May 03, 2018 2:27 pm
Forum: Geeetech I3 Pro W
Topic: Patchy Prints
Replies: 6
Views: 1418

Re: Patchy Prints

congrats!
by Gingko
Wed May 02, 2018 6:26 pm
Forum: Geeetech Delta Series
Topic: initial setup issue
Replies: 1
Views: 1188

Re: initial setup issue

try to increase the voltage of A4988 of that motor to 1.0V or 1.1V.
by Gingko
Wed May 02, 2018 10:57 am
Forum: Geeetech I3 Pro W
Topic: Patchy Prints
Replies: 6
Views: 1418

Re: Patchy Prints

1 may be the temperature is a little low, you can increase 10 degrees to have a try.
2 you can also refer to these posts:
viewtopic.php?f=19&t=18507&start=10
viewtopic.php?f=19&t=18650
by Gingko
Wed May 02, 2018 9:58 am
Forum: Geeetech Delta Series
Topic: Rostock LCD Just shows the four rows of green squares
Replies: 2
Views: 1203

Re: Rostock LCD Just shows the four rows of green squares

here is a post discussing similar problems:
viewtopic.php?f=23&t=17040

and for GTM32 pro, maybe you should burn the bootloader at first and then upload the correct firmware.
by Gingko
Sat Apr 28, 2018 5:09 pm
Forum: Software
Topic: Driver for A30 with easyprint 3D sotfware
Replies: 4
Views: 2863

Re: Driver for A30 with easyprint 3D sotfware

I found something that may help u

Easyprint--How to add your printer(If the software does not have your printer in default):
viewtopic.php?f=45&t=60680
Easyprint 3D slice problem.
viewtopic.php?f=44&t=60705
by Gingko
Sat Apr 28, 2018 3:37 pm
Forum: Geeetech Delta Series
Topic: Delta G2s
Replies: 2
Views: 1855

Re: Delta G2s

maybe you can try to check the endstops.
this post can be referenced:
viewtopic.php?f=13&t=17042
by Gingko
Thu Apr 26, 2018 11:23 am
Forum: Software
Topic: Driver for A30 with easyprint 3D sotfware
Replies: 4
Views: 2863

Re: Driver for A30 with easyprint 3D sotfware

have you tried to upgrade the EasyPrint to version 1.1.7?
by Gingko
Wed Apr 25, 2018 9:27 am
Forum: Geeetech I3 Pro W
Topic: New build, ERR:MAXTEMP
Replies: 7
Views: 2321

Re: New build, ERR:MAXTEMP

There is a post for similar problem:
viewtopic.php?f=23&t=17030
by Gingko
Tue Apr 24, 2018 2:01 pm
Forum: Geeetech A30 Series
Topic: Extruder is not heating
Replies: 3
Views: 1973

Re: Extruder is not heating

Maybe refer to this
viewtopic.php?f=19&t=17039