Search found 36 matches

by rmrodrigues
Thu Nov 05, 2015 5:54 pm
Forum: Extruder
Topic: Filament - Where to buy and which I should buy?
Replies: 3
Views: 1877

Re: Filament - Where to buy and which I should buy?

Hi Mark. Thank you for the response.
Do you use a filter for lubrification right?

Thanks.
Cheers,
RMRodrigues.
by rmrodrigues
Thu Nov 05, 2015 5:21 pm
Forum: Extruder
Topic: Filament - Where to buy and which I should buy?
Replies: 3
Views: 1877

Filament - Where to buy and which I should buy?

Hi,
Which is the filament maker you advise to buy? There is an specific brand?
Should I to buy a lubrication filament or not? I've a filter for lubrification.

Thank you.
Cheers.
RMRodrigues.
by rmrodrigues
Sat Oct 31, 2015 3:56 pm
Forum: Extruder
Topic: Geeetech Prusa i3 pro c dual extruder question
Replies: 6
Views: 4347

Re: Geeetech Prusa i3 pro c dual extruder question

Hi cedrij,
Thank you for your reply. It looks ok. Could you share the 3d model?
Best,
RMRodrigues
by rmrodrigues
Fri Oct 16, 2015 4:55 am
Forum: Software
Topic: Geeetech Prusa i3 pro c firmware management
Replies: 0
Views: 2120

Geeetech Prusa i3 pro c firmware management

Hi there,
Is there a repository that I can clone/fork to contribute with some changes?
Thanks.
Best,
RMRodrigues.
by rmrodrigues
Thu Oct 15, 2015 6:20 pm
Forum: Extruder
Topic: Geeetech Prusa i3 pro c dual extruder question
Replies: 6
Views: 4347

Re: Geeetech Prusa i3 pro c dual extruder question

Hi Eric,
Thank you for the reply. I'm asking that because usually the cooler and the fan are placed on the front side of the extruder, as it was made on model B, I think.
Thanks.
Best,
RMRodrigues.
by rmrodrigues
Thu Oct 15, 2015 6:05 am
Forum: Extruder
Topic: Geeetech Prusa i3 pro c dual extruder question
Replies: 6
Views: 4347

Geeetech Prusa i3 pro c dual extruder question

Hi there,
I've bought a Geeetech Pro C and I've a doubt related with the extruder.
Why this dual extruder has only one fan and any cooler?
Usually, each extruder has a cooler + fan.
Do you advise change that and add a cooler + fan for each extruder?
Best,
RMRodrigues