Geeetech

Tomorrow i'll write a small tutorial. I need 4 days for this work because i have not any guide. With a tutorial you can do this work in a couple of hour.

Hi!
I installed the mainboard SKR 1.4. turbo on my A10M and everything is ok! I am very happy.
But only 1 questio.I want to upload the HEX file of A10M in the download area in this site. But how can upload a HEX file in SKR??

Thank you!

Hi! I have installed SKR 1.4. all is ok but i dont't know how connect th eextruder motor In motor is 4 cables black,red,green and blue. How is conneced on SKR? THANK you very much!!

Hi!
I must to change the cable and connector of my great a10M. Can you someone tell me how th cable is wired on the motor? Pin 1 is? pin2 is? etc etc Thank you very very much!

Hi! My motherboard of A10M is broken (i broak it by error.My mistake). I replace it with Arduino mega and ramps. I Load the Marlin 1.1.8 into Arduino ad it is ok. But if i load the file HEX i founded in Geeetech dowload pages ,nothing happens. I uploaded with cura and seems all ok. But on displaty a...

Hi!
If i unplugged the termistor the temperature on display is always 70.

Nothing happens if i unplugged the cable.

Hi! Yes. If i unplugged the termistor the temperature is -14.But the problem is not the extruder temperature. The problem is the BED temperature. On display is always 70 or 71. If i unplugged the cable ob motherboard notjng changes. See the picture in attachment. Thank you IMG_20200601_120323 (768 x...

Hi!
Th temperature of hotend is ok. I put new termistor.Maybe is 5 degrees higher.But i can control it.
p.s is it possible to heat but only if a set the temperature at 72 degrees (on display 70/72).And the heat goes to max.

Hi! The display of bed temperature is always on 70 degrees and the bed is off,cold.I can't set the temperature on 60,for example. Why? Thank you very much!