Search found 4 matches

by derekpittx
Wed Jul 01, 2020 2:02 pm
Forum: Geeetech A10 Series
Topic: SKR V1.3 on the A10 - Any pointers?
Replies: 39
Views: 53830

Re: SKR V1.3 on the A10 - Any pointers?

I have an SKR 1.3 on the way, arriving Monday since it was actually cheaper to upgrade than to replace. I'll probably step up to the TMC2130's at some later date but for now it's just a straight-up replacement of the GT2560 v3 I'm after.
by derekpittx
Thu May 28, 2020 8:16 pm
Forum: Geeetech A10 Series
Topic: SKR V1.3 on the A10 - Any pointers?
Replies: 39
Views: 53830

Re: SKR V1.3 on the A10 - Any pointers?

I have an SKR 1.3 on the way, arriving Monday since it was actually cheaper to upgrade than to replace. I'll probably step up to the TMC2130's at some later date but for now it's just a straight-up replacement of the GT2560 v3 I'm after.
by derekpittx
Mon May 04, 2020 3:32 am
Forum: Geeetech I3 Pro B
Topic: I3 pro B setup... HELPPPP
Replies: 13
Views: 7030

Re: I3 pro B setup... HELPPPP

I still cannot get the up/down movement to work, both motors try to turn the shafts but seem to just be vibrating in place and not atcually turning the shafts.
tubemate mobdro and authorityapk
by derekpittx
Mon Feb 10, 2020 2:31 pm
Forum: Geeetech A10 Series
Topic: Problems getting started: All three axes move in negative direction ignoring end stops
Replies: 7
Views: 14912

Re: Problems getting started: All three axes move in negative direction ignoring end stops

I bought an A10 printer used and defective (burned stepper driver and a burned trace on the pcb). I managed to repair it. Directly via the LCD panel I can drive all axes correctly, also heat and extrude. But if I want to control the printer with Repetier-Host or EasyPrint3D, only the axis referenci...