Geeetech

THANKS. SOLVED.

THANKS. SOLVED

Hi, I have install the new firmware A20T_G05_V1.1.8-2.1-3DTOUCH.hex on my A20T. I have follow the steps provide by Geeetech by video. Unfortunately I'm facing a lot of issue to setup the 3DTouch. 1) During the callibration of the auto-home, the Z-axis will beat against the bed and tries to force 2-3...

Thanks for the reply.
I have install a btouch to prevent the problem.
Seams the hex file on your site don't work correcly.
Impossible to calibrate.

Hi, I have levelled my printer A20T following the documentation and video provide by Geeetech on the site. I have printed the model successfully. But when I like to print some model higher, I have a problem on the first layer and the printing don't continue correctly at quality level spoking. Then I...

Hi, Thanks. I think is not clear my message. My issue it's with the part 3 in 1 out hotend kit for A10T A20T (SKU:700-001-1265). Sometimes the filament go out, sometimes not. The temperature seams OK : 215 °C for PLA. Filent 1 it's working but the others 2 color nothig is going out. the motor pushin...

Hi,

I have buy a new extruder for my A20T. Do you have the connection schema with the board ?
I have try to reconnect like the preview one was connected, it heat but not working well.
The PLA is not pushing out correctly.

I'm pretty sure is my wire connection wrong.

Thanks in advance

Best regards

Same issue. I have a return error st500 time out.