Geeetech

For a consistent way to upload firmware on GT2560 4.0, please see vert 's youtube video Here is his answer in another forum thread http://www.geeetech.com/forum/viewtopic.php?f=20&t=69699&p=105577#p105579 The "Need to hold the printer's reset button while updating the firmware to update!!!" is not e...

@vert Thanks your suggestion (video youtube) for pressing + holding the reset button and releasing the worked ! So I uploaded 3 times a firmware without a failure to upload !! The reset before uploading firmware is needed to make the bootloader start executing, - but it should happen automatically (...

Thanks for you answer Then I will wait a few months , like until summer and then get a 2nd board, (maybe it will be an improved version by then) Then i ll try to program the old one with an ISP programmer with some peace of mind that i have a spare board Also i ll try to program new board via serial...

And also made sure i have 250000 baud rate

Hello thanks for your answer, just the question was if i can compile it (i have a A10T) e.g. correct minor issues (and in future make some upgrades) minor issues - correct x,y offsets (discovered by clicking auto-home are -15, -8), - correct the Z-axis maximum height is wrongly set to 260mm, but i o...

Any news about this ?

I also have GT2560 V4.0 (i own an A10T)