Geeetech

I swapped the Cable and motor together.
Simply unplugged from Y and plugged into X on the mothernoard

Hi, That should be caused by damage to the motor cable, you need to replace it. Hi William and thanks for the suggestion. As i mentioned earlier, when I swap the cable from the Y port to X, the motor works, so the issue could not with the cable. I believe I have received a damaged replacement GT-25...

Hi, You can see if you can manually push the hotbed to move, Then check the rail and the lock nut of the hotbed. I hope this can help you. Hi William. The bed moves freely. I have swapped the cables between the X and Y, the bed can move, (by controlling X) but the extruder does not when attempting ...

Hi. I recently had a problem with my printer giving a MAXTEMP BED error. and was advised that the fix was to replace the motherboard (GT-2560 REV A+). [Previous thread: http://www.geeetech.com/forum/viewtopic.php?f=82&t=68811#p101327 ] I replaced the board with a brand new GT-2560 A+ and the previou...

thanks.. I have replaced the motherboard, but am now having new issues that I will open anew thread for.

Hi William thanks for the reply.
as I mentioned earlier, I have tried unplugging the hotbed thermistor as well as swapping the thermistors for the bed and the hotend.

The error does not change.

Looks like my current choices are to replace the motherboard or get a new printer.

Hi. I have the same issue. I have a i3 Pro W that I have not used for a while, but when I went to use it yesterday, I found that the bed temp was showing at 43°C when I turned the printer on. I successfully started a print, but after half an hour, the bet temp went way up and then the printer shut d...