Search found 14 matches

by Bs2000
Mon Jun 24, 2019 9:09 pm
Forum: Geeetech I3 M201
Topic: First print problem
Replies: 11
Views: 1789

Re: First print problem

Kactus thanks, while sometimes it is a little hard to follow, I can understand for the most part. But what I am confused about is that you told me to measure the extruder step and if need be change it to 1mm. I do understand the estep however you said you changed to 101 but your screen shows 9* some...
by Bs2000
Thu Jun 20, 2019 4:33 am
Forum: Geeetech I3 M201
Topic: First print problem
Replies: 11
Views: 1789

Re: First print problem

Measure again, compare it with the line you took earlier. If it's in a good position, you don't have to do anything. Otherwise, in the printer configuration change the number of steps to 1mm for the extruder motor.
by Bs2000
Wed Jun 19, 2019 4:25 am
Forum: Geeetech I3 M201
Topic: First print problem
Replies: 11
Views: 1789

Re: First print problem

Thanks. You didn't mention if that setting was the correct one. Is it the manual extruder speed
by Bs2000
Tue Jun 18, 2019 6:51 pm
Forum: Geeetech I3 M201
Topic: First print problem
Replies: 11
Views: 1789

Re: First print problem

Thanks kaktus, :D would the stepper setting be the manual extruder speed?
by Bs2000
Tue Jun 18, 2019 7:16 am
Forum: Geeetech I3 M201
Topic: First print problem
Replies: 11
Views: 1789

Re: First print problem

Also I have firmware 1.0.0.4 I stalled...
by Bs2000
Tue Jun 18, 2019 4:41 am
Forum: Geeetech I3 M201
Topic: First print problem
Replies: 11
Views: 1789

First print problem

Hi everyone, I finally have my M201 all setup and tested all axis to make sure it runs smoothly. I downloaded a simple sharks tooth file opened it in easyprint3d with all the following settings (see pics) when I slice it and print my filiment comes out at first like string then starts to blob up and...
by Bs2000
Fri May 31, 2019 8:12 pm
Forum: Geeetech I3 M201
Topic: Extruder mount
Replies: 1
Views: 438

Extruder mount

So when I go to mount the extruders the holes pre drilled leave the bracket setting on a mount screw. Am I doing something wrong?
by Bs2000
Sat May 25, 2019 8:08 pm
Forum: Geeetech I3 M201
Topic: Fan placement
Replies: 5
Views: 985

Fan placement

So building my M201 and the directions show the fan bolting onto the A1 with a fan cut out behind stepping motor on left side. Well mine doesn't have any cutouts or holes so where do I place fan?
by Bs2000
Wed May 22, 2019 5:54 am
Forum: Products FAQ
Topic: Geeetech Prusa I3 M201
Replies: 1
Views: 4632

Re: Geeetech Prusa I3 M201

Anyone other than a sales pitch?
by Bs2000
Mon May 13, 2019 8:48 am
Forum: Geeetech I3 M201
Topic: M201 and 3DTouch.
Replies: 5
Views: 724

Re: M201 and 3DTouch.

Well I sure hope so seeing I had just purchased this machine and for the amount of money I paid I would have went with a newer model if I know all this beforehand