Geeetech

Hey William,

bought it in March 2019 via Amazon in Germany. Dont have the exact order number anymore.

Sincerely

Max

I wanted to make a picture, but this time, he didnt even make it to start the print, it was still busy doing the Extruder warm-up :/

If that broken motherboard chip is correct, where can i get a replacement part?

Sincerely

Sack

Can i download a test print somewhere here in the forum?


EDIT:

I found the SD card with the test models, the first layer again looks really really good, then, when it comes to the walls of the 2nd layer it crashes....

Hi William,

I only print with it connected to the PC.
Just today i tried it via SD ( because i wanted to be sure that the printer is not getting some weird signalls from the PC)

But in general the issue seems to be the same!

Hello Everybody, I have a problem with my A10M Printer. Lately he just sops mid-print, 3 days ago it stopped sometimes at night, two days ago after around 4h, no it cant even finish the first two layers. The Printer just stops in place. every light (endstops, Autolevel-probe and Display) start flash...

But on the left side the discrepancy seems to be too great, so the PLA seems to stay in a "round" form and is not properly adhering at all :/

I now switched filaments because i thought it might be a problem with the filament itself. I now use Black and Yellow Geetech filament but still get problems with my prints, there seems to be some underextrusion and in some points its just seems to clog :( I cleared the hotend as well as i could and...

Hey Guys, its me again :/ I had a good run with my prints until my filament ran out and now i replaced ith with some golden Amolen Filament https://www.amazon.de/AMOLEN-Drucker-Filament-Materialien-Filament/dp/B07H8217NG/ref=sr_1_5?crid=XMJ019WR9493&keywords=filament+amolen+gold&qid=1561094218&s=gat...

Ok, so with the new files i was able to update the firmware again, it now has the menu buttons etc. and when i ask it to auto level it runs an auto level.

But if i now start it from cura with "print via usb" it does auto leveling and then at the end of it stops and doest start printing at all...

Thank you for the file. Do you know where i can get the 1.8.5. version? i only have the 1.8.9 version of arduino IDE