Geeetech

Thank you i will try it.

thank you for your answer, but how do I check the deviation and which gcode do I have to use?

I also blew one of my fuses and i found a spare part on Aliexpress, didn´t receive it yet so I can´t tell you if it works. Just search SMD fast blow fuse on Aliexpress and you will find the right thing

Sorry I didn´t respond, I didn´t see there were responds to my question.

If anyone else has this problem my problem was that the extruder wasn´t tight enough. I bought the metal extruder and now everything works fine again

Hello there, I have recently bought a 3d touch sensor for my A10. I have installed the sensor successfully, but the auto bed levelling doesn´t work as expected. The 3d touch measures all points on the plate, but when I print on one side the nozzle seems too high and on the other side it is definitel...

I have my A10 for two weeks now and everything worked fine in the beginning. During my last print severe underextrusion occured. I cleaned the complete hotend did calibration of the extruder and Bed levelling, but I simply cannot print. My problem is that hardly any material comes out of the nozzle ...

I have my A10 for two weeks now and everything worked fine in the beginning. During my last print severe underextrusion occured. I cleaned the complete hotend did calibration of the extruder and Bed levelling, but I simply cannot print. My problem is that hardly any material comes out of the nozzle ...

Search the .ino file in the zip folder and open IT in the Arduino IDE. Open the configurarion.h tab and change the HEATER_0_MAXTEMP and the Bed Maxtemp. Then compile and upload IT via Arduino IDE If you want a maximum of 250 you habe to Set the temperature to 265 and for the Bed also +15 to your des...