Search found 5 matches
- Fri Oct 26, 2018 7:14 pm
- Forum: Geeetech A10 Series
- Topic: Geeetech A10 firmware Marlin 1.1.9
- Replies: 78
- Views: 154271
Re: Geeetech A10 firmware Marlin 1.1.9
I tested with a webcam taking a photo every Z change (= new layer) and found out that the shift is exactly at the 128th layer (printed in 0.2mm per Layer, but I think the high of a single layer doesn't matter). Maybe this helps with finding failures for the bad layer shift. At the 128th layer, the ...
- Wed Oct 24, 2018 2:37 pm
- Forum: Geeetech A10 Series
- Topic: Geeetech A10 firmware Marlin 1.1.9
- Replies: 78
- Views: 154271
Re: Geeetech A10 firmware Marlin 1.1.9
This firmware is much better than the stock firmware! However, i'm getting bad layer shifts. I can hear the Y Axis stepper clicking while printing the infill. I'm not sure what to do. I guess i'll need to go back to the stock firmware. Does anyone have a link to the stock firmware in a hex file? --...
- Sat Oct 20, 2018 7:08 pm
- Forum: Geeetech A10 Series
- Topic: A10 GT2560 V3.0 board wiring for 3d touch
- Replies: 11
- Views: 22798
Re: A10 GT2560 V3.0 board wiring for 3d touch
Thank you very much, this helped me a lot, too!Gingko wrote: ↑Sat Oct 20, 2018 4:05 pmSchematic for GT2560 V3.0: https://github.com/Geeetech3D/Diagram/b ... .0_SCH.pdf
Wiring:
GT2560 V3.0 WIRING2.png
And you can reverse the direction of the Z motor according to user manual:
1.png
- Sat Oct 20, 2018 7:04 pm
- Forum: Geeetech A10 Series
- Topic: DOA
- Replies: 8
- Views: 11536
Re: DOA
Have you selected to correct voltage in the PSU (e.g. 230V in Europe)? There is a small rectangle hole on one side of the PSU where you switch the voltage with a iron clip or screw driver. But disconnect the power cable before you switch it.
- Sun Oct 07, 2018 4:48 am
- Forum: Geeetech A10 Series
- Topic: Geeetech A10 firmware Marlin 1.1.9
- Replies: 78
- Views: 154271
Re: Geeetech A10 firmware Marlin 1.1.9
Hallo MichaelK and 3D printing friends! I could compile your Marlin 1.1.9 (downloaded from thingiverse) together with aarli's configuration files from the post on page 3 in this thread. I used Arduino IDE 1.8.7 in Win10x64 and uploaded the firmware directly by USB to the GeeeTech A10. The embedded b...