Geeetech

Look at this pic... wire it as u see there and u will be fine.
U will have to solder it.

As I know (now)... there are 3 versions of A10 out there. Depending on the GT2560 board version. Versions of A10: 1. Rev A (1.0) 2. Rev b (2.0) 3. Rev v3.0 A10M is the multicolor version. The hotend mount looks different too at each version. There are versions with and without preinstalled BL-Touch-...

Right... this could fit. Simple to mod.

Thx

Easy... the orange one is the signal one. As I know red and orange here must be swaped.

Didn't know that there are different versions with the same name. I know better now. Thanks!
I do not want to annoy anyone... Sorry for that.

Hi there,

is there someone out there who would share her/his E3D v6 hotend mount?
I did search on thingiverse... but I cant find one.

Need it for the classic A10 (Not A10M etc...)

U got a A10M then... Thats a different printer. We are talking about the A10 here.

Would you make it for the A10 (GT2560 Rev B) too?

Board: GT2560 Rev B Endstops connector (schematic): VCC | VCC Z_MAX | Z_MIN GND | GND VCC | VCC Y_MAX | Y_MIN GND | GND VCC | VCC X_MAX | X_MIN GND | GND VCC = 5V (Not needed if you use a voltage devider at 24V for the sensor, be sure to devide the voltage to <=5V) *_MIN, *_MAX = Signal (IN) GND = G...