Search found 8 matches

by axiom
Wed Mar 25, 2020 9:35 pm
Forum: Geeetech A10 Series
Topic: SKR V1.3 on the A10 - Any pointers?
Replies: 21
Views: 5611

Re: SKR V1.3 on the A10 - Any pointers?

Matsubaa wrote:
Wed Mar 25, 2020 12:54 am
It was overkill for just the printer but this is the exact kit I bought: https://www.amazon.com/gp/product/B01MC ... UTF8&psc=1
Nice! Thank you!
by axiom
Sun Mar 22, 2020 9:40 pm
Forum: Geeetech A10 Series
Topic: SKR V1.3 on the A10 - Any pointers?
Replies: 21
Views: 5611

Re: SKR V1.3 on the A10 - Any pointers?

I have an original A10. I am looking to replace the board with an SKR. Looking for some advice to what connectors the SKR uses. I believe its the JST XHP. Is this the case?

Thanks
by axiom
Wed Sep 26, 2018 1:49 am
Forum: Geeetech A10 Series
Topic: A question about the Cura configuration for the A10.
Replies: 1
Views: 2263

A question about the Cura configuration for the A10.

Does anyone have the settings they use for the a10 in cura that they can share?

Im very new to printing and I followed Jimmy Shaws video on YT on how to setup the a10 in cura. Was wondering if they were the same.
by axiom
Tue Sep 25, 2018 11:47 pm
Forum: Geeetech A10 Series
Topic: Geeetech A10 firmware Marlin 1.1.9
Replies: 78
Views: 53756

Re: Geeetech A10 firmware Marlin 1.1.9

I updated to the marlin 1.1.9 FW. I ran a test, and I had layer shifting. It was really bad. So I switched back to the original FW and fixed the fan issue. Anyone had any layering issues with 1.1.9?
by axiom
Tue Sep 25, 2018 2:40 am
Forum: Geeetech A10 Series
Topic: A10 Part cooling fan FIXED!!!! Thanks to combat341
Replies: 3
Views: 3500

A10 Part cooling fan FIXED!!!! Thanks to combat341

This needs to be a sticky!!!!!

Kudos to combat341 for this

I thought that this needed to be a separate thread, rather buried in a post.

I did this and it works.

https://imgur.com/a/uPrCTsK

Thanks again combat341!!!!
by axiom
Sun Sep 09, 2018 7:51 pm
Forum: Geeetech A10 Series
Topic: A10 auto level sensor
Replies: 37
Views: 21865

Re: A10 auto level sensor

thanks for the info. I will look into it
by axiom
Wed Sep 05, 2018 10:34 pm
Forum: Geeetech A10 Series
Topic: A10 auto level sensor
Replies: 37
Views: 21865

A10 auto level sensor

I am new to 3d printing. I would like to install a sensor for auto bed leveling. I am unsure how to go about this. Does anyone have information on how to do this?

Thank you