The question is: Can you use the the second nozzle heater pins somehow to heat the bed? The GT2560 board bed heater went bad and I need to find pins to use to heat my bed. Is it possible? If so, HOW?
Search found 4 matches
- Sat Mar 09, 2019 4:05 pm
- Forum: Firmware
- Topic: how to change pins configuration in firmware
- Replies: 20
- Views: 49483
Re: how to change pins configuration in firmware
The question is: Can you use the the second nozzle heater pins somehow to heat the bed? The GT2560 board bed heater went bad and I need to find pins to use to heat my bed. Is it possible? If so, HOW?
- Fri Mar 08, 2019 9:58 am
- Forum: Control Board
- Topic: Delta M301 firmware ( Marlin )
- Replies: 13
- Views: 26407
Re: Delta M301 firmware ( Marlin )
I have the same problem on my 301. I have had mine for about a year or so now just sitting on a shelf collecting dust. I will pull it down and fix these problems. who did you contact again on getting the kit? Maybe William can help me get this kit?
- Sat Feb 09, 2019 3:19 am
- Forum: Firmware
- Topic: how to change pins configuration in firmware
- Replies: 20
- Views: 49483
Re: how to change pins configuration in firmware
Now how about changing the E1 over to the heat Bed. There are different pin configurations in the ultimaker.pins. #define E1_STEP_PIN 49 #define E1_DIR_PIN 47 #define E1_ENABLE_PIN 48 // // Temperature Sensors // #define TEMP_0_PIN 8 // Analog Input #define TEMP_1_PIN 9 // Analog Input #define TEMP_...
- Tue Aug 07, 2018 9:25 am
- Forum: LCD Panel
- Topic: Display problems of LCD2004/12864
- Replies: 17
- Views: 109529
Re: Display problems of LCD2004/12864
How about a pin number on both the GT2560 and the LCD 12864 and show what each pin does such as the knobs a and b connections ECT.. I think some of the wire ribbons are different out there like the ones Anet used for their 12864 LCD... Can this be done?