Search found 4 matches

by kernst1016
Sat Mar 09, 2019 4:05 pm
Forum: Firmware
Topic: how to change pins configuration in firmware
Replies: 20
Views: 49473

Re: how to change pins configuration in firmware

William wrote:
Wed Feb 13, 2019 11:27 am
It is based on the hardware.
When you swap the pins of them,you need to care the hardware also.

The question is: Can you use the the second nozzle heater pins somehow to heat the bed? The GT2560 board bed heater went bad and I need to find pins to use to heat my bed. Is it possible? If so, HOW?
by kernst1016
Fri Mar 08, 2019 9:58 am
Forum: Control Board
Topic: Delta M301 firmware ( Marlin )
Replies: 13
Views: 26391

Re: Delta M301 firmware ( Marlin )

I have the same problem on my 301. I have had mine for about a year or so now just sitting on a shelf collecting dust. I will pull it down and fix these problems. who did you contact again on getting the kit? Maybe William can help me get this kit?
by kernst1016
Sat Feb 09, 2019 3:19 am
Forum: Firmware
Topic: how to change pins configuration in firmware
Replies: 20
Views: 49473

Re: how to change pins configuration in firmware

Now how about changing the E1 over to the heat Bed. There are different pin configurations in the ultimaker.pins. #define E1_STEP_PIN 49 #define E1_DIR_PIN 47 #define E1_ENABLE_PIN 48 // // Temperature Sensors // #define TEMP_0_PIN 8 // Analog Input #define TEMP_1_PIN 9 // Analog Input #define TEMP_...
by kernst1016
Tue Aug 07, 2018 9:25 am
Forum: LCD Panel
Topic: Display problems of LCD2004/12864
Replies: 17
Views: 109468

Re: Display problems of LCD2004/12864

How about a pin number on both the GT2560 and the LCD 12864 and show what each pin does such as the knobs a and b connections ECT.. I think some of the wire ribbons are different out there like the ones Anet used for their 12864 LCD... Can this be done?