Geeetech

thanks for your reply...there is a test to check the quality of my sensor? I want to be sure that the product is not broken.
thanks

now i use the firmware: 1.1.x "bugfix" snapshot Patches after 1.1.9 Supports Arduino 1.6.8 and up my autoleveling sensor is this: http://www.geeetech.com/wiki/index.php/3DTouch_Auto_Leveling_Sensor so, the last one http://marlinfw.org/meta/download/ to test the autoleveling, i put a cube 5x5x5mm on ...

Hi, i have a geeetech aluminum version with a motherboard arduino mega + ramps 1.4 + DRV8825 + BLtouch. My problem is on Z axis, infact, after the autoleveling, my 3d printer compensates in the wrong direction, infact if the bed is more down (respect the "0 point", so the center of the bed) on left ...

hi, on my aluminum 3d printer, i install an arduino mega + ramps 1.4 + drv8825 + bltouch.
can you give me a link to download the firmware fr this combo?

i upload the firmware on the page "firmware", but i can't print correctly.
thanks and scuse me for my "perfect" english

thanks a lot to all people for the great help!

thank you so much

hi, i buy a new motherboard and a BlTouch...can you send me a correct firmware?

my motherboard is arduino mega+ ramps 1.4, i install 4 DRV8825 drivers (x, y, z, e0) with 1/32 config.

thanks for your help