Hey everyone,
I wanted to upload the firmware for my i3 pro a 3 in 1 control box.
This error appeared, do someone know how I can fix this?
Search found 4 matches
- Thu Nov 17, 2016 10:53 pm
- Forum: Firmware
- Topic: How to install the firmware for GT2560
- Replies: 141
- Views: 649800
- Thu Nov 17, 2016 9:29 pm
- Forum: Stepper Motor
- Topic: Possible solutions for motors do not move
- Replies: 39
- Views: 180209
Re: Possible solutions for motors do not move
Hey, @William
I tried it, but same problem, the steppe driver of the x-achses works fine on the y-motor, so that shouldn´t be the problem.
I also swaped the end stop pugs, but no effect on the motor.
Could it be a failure in the software?
Thanks for helping
I tried it, but same problem, the steppe driver of the x-achses works fine on the y-motor, so that shouldn´t be the problem.
I also swaped the end stop pugs, but no effect on the motor.
Could it be a failure in the software?
Thanks for helping
- Thu Nov 17, 2016 12:49 am
- Forum: Stepper Motor
- Topic: Possible solutions for motors do not move
- Replies: 39
- Views: 180209
Re: Possible solutions for motors do not move
Hello, I bought a new I3 Pro A, after the building and wirering I tried to start the printer. The problem: When I choose "auto home" the x-achses should move to "-", it moves to "+". Today I tried again and now the x-achses is fast moving/shaking one or two mm to - and then one or two mm to +. Do ha...
- Wed Nov 16, 2016 11:56 pm
- Forum: Products FAQ
- Topic: Prusa i3 Pro A X-achses shaking
- Replies: 1
- Views: 4412
Prusa i3 Pro A X-achses shaking
Hello, I bought a new I3 Pro A, after the building and wirering I tried to start the printer. The problem: When I choose "auto home" the x-achses should move to "-", it moves to "+". Today I tried again and now the x-achses is fast moving/shaking one or two mm to - and then one or two mm to +. Do ha...