Geeetech

Hi,
I had the same problem. I wrote to Geeetech and they will send me, this board + cable, for 8$.

Bye
Marco

To those, who have made the request?

Thanks

Hi to everybody,
I’ve a problem with the MicroSD reader.
Sometimes it didn’t read the card. I think , that the problem could be the switch to control if the card is inserted.
Do you know if is possible to change the board, with this connector?
Thanks in advance
Bax

@Marco So you mean the Sensor works fine during the calibration but the nozzle is not in the right position when printing? If you do,decrease the value "-1.4" in the following codes: CODE: SELECT ALL #define Z_PROBE_OFFSET_FROM_EXTRUDER -1.4 You can decrease it to "-1.9" first to see if it makes a ...

@Marco So you mean the Sensor works fine during the calibration but the nozzle is not in the right position when printing? If you do,decrease the value "-1.4" in the following codes: CODE: SELECT ALL #define Z_PROBE_OFFSET_FROM_EXTRUDER -1.4 You can decrease it to "-1.9" first to see if it makes a ...

Hi to everybody, yesterday, I mounted this sensor , on my I3 Pro B but, but all work bad. I did the modifications on Firmware Marlin, in Configuration.h and pins.h, like in the instructions. I saw the wiki , where is an explanation of calibration : http://www.geeetech.com/wiki/index.php/3DTouch_Auto...