Search found 6 matches

by baxbax
Thu Jun 13, 2019 8:22 pm
Forum: Geeetech A30 Series
Topic: Help: Micro SD card reader on Touchdisplay board damaged
Replies: 1
Views: 991

Re: Help: Micro SD card reader on Touchdisplay board damaged

Hi,
I had the same problem. I wrote to Geeetech and they will send me, this board + cable, for 8$.

Bye
Marco
by baxbax
Fri Jun 07, 2019 1:59 pm
Forum: Geeetech A30 Series
Topic: MicroSD reader
Replies: 2
Views: 400

Re: MicroSD reader

To those, who have made the request?

Thanks
by baxbax
Fri Jun 07, 2019 4:18 am
Forum: Geeetech A30 Series
Topic: MicroSD reader
Replies: 2
Views: 400

MicroSD reader

Hi to everybody,
I’ve a problem with the MicroSD reader.
Sometimes it didn’t read the card. I think , that the problem could be the switch to control if the card is inserted.
Do you know if is possible to change the board, with this connector?
Thanks in advance
Bax
by baxbax
Tue Oct 25, 2016 2:04 pm
Forum: Geeetech A20M
Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
Replies: 326
Views: 195535

Re: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer

@Marco So you mean the Sensor works fine during the calibration but the nozzle is not in the right position when printing? If you do,decrease the value "-1.4" in the following codes: CODE: SELECT ALL #define Z_PROBE_OFFSET_FROM_EXTRUDER -1.4 You can decrease it to "-1.9" first to see if it makes a ...
by baxbax
Tue Oct 25, 2016 1:22 am
Forum: Geeetech A20M
Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
Replies: 326
Views: 195535

Re: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer

@Marco So you mean the Sensor works fine during the calibration but the nozzle is not in the right position when printing? If you do,decrease the value "-1.4" in the following codes: CODE: SELECT ALL #define Z_PROBE_OFFSET_FROM_EXTRUDER -1.4 You can decrease it to "-1.9" first to see if it makes a ...
by baxbax
Sun Oct 23, 2016 9:12 pm
Forum: Geeetech A20M
Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
Replies: 326
Views: 195535

Re: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer

Hi to everybody, yesterday, I mounted this sensor , on my I3 Pro B but, but all work bad. I did the modifications on Firmware Marlin, in Configuration.h and pins.h, like in the instructions. I saw the wiki , where is an explanation of calibration : http://www.geeetech.com/wiki/index.php/3DTouch_Auto...