Geeetech

Safer than Ebay. Especially if you pay with Paypal.

No, it was a problem with the build instructions. They show the wrong connection points
for the cables. It took a combination of online research and experimentation to get
them plugged into the right positions on the control board. The machine is working now.

I'm having a slightly different problem with my Z-axis motors.
Only one motor will run. If I swap the cables, then the other motor will run.
So the motors are good.
I have tried new driver boards and the problem remains.
The X and Y work fine.
Thanks

That is the firmware that I have already downloaded and tried. It doesn't even have the X-axis stepper moving in the right direction. I'm looking for a complete configuration, proven to work with my printer. If these printers are capable of working properly, surely the manufacturor should be able to...

I ordered a set of driver boards from Amazon.com. Cheap, and arriving Saturday. I'll report back when I get them.

Hello! Does anyone, out there, have a copy of the firmware for my machine that is known to work/has the right settings already set? Aside from one of the Z-Axis drivers not working, and manual control in Reppiteer not quite right, it seems to want to work. If I send it a sliced file, it goes through...

Thank you. I'm now using 1.0.1. Have successfully reversed the X-Axis stepper.
I have confirmed that both Z-Axis steppers are OK. It must be the driver board.
How do I get another driver board?

Hello everyone! Well, I have successfully assembled my Geeetech Prusa i3 Pro C Dual Extruder 3D printer. Here is where I stand. All endstops seem to work. The Y axis is moving in the correct direction. The X axis seems to be moving backwards. And only one Stepper motor, on the Z axis works. All heat...