Search found 27 matches
- Wed Apr 24, 2019 6:28 am
- Forum: Geeetech I3 Pro W
- Topic: Power Supply Issues
- Replies: 4
- Views: 6455
Re: Power Supply Issues
Did you check the 220/115 ac switch ?
- Sat Nov 04, 2017 1:23 pm
- Forum: Feedback&Suggestion
- Topic: Duplicator 5
- Replies: 2
- Views: 6068
Re: Duplicator 5
Thank you for the fun and quality product. Also the very good youtube instructions .
- Wed Nov 01, 2017 10:20 pm
- Forum: Feedback&Suggestion
- Topic: Duplicator 5
- Replies: 2
- Views: 6068
Duplicator 5
100mm longer Z axis connection wire , or more clearance between build platform and back of printer . Longer bolts for build platform on the springs .
Better quality cooling fan to cool the control board , mine has to be replaced due to noisy bearing already .
Better quality cooling fan to cool the control board , mine has to be replaced due to noisy bearing already .
- Mon Oct 16, 2017 11:33 am
- Forum: Feedback&Suggestion
- Topic: Z-axis wireing in the duplicator 5
- Replies: 3
- Views: 6923
Re: Z-axis wireing in the duplicator 5
No,I am using jumper wires .
- Thu Oct 12, 2017 4:03 am
- Forum: Feedback&Suggestion
- Topic: Z-axis wireing in the duplicator 5
- Replies: 3
- Views: 6923
Z-axis wireing in the duplicator 5
https://www.thingiverse.com/groups/geeetech-duplicator-5/topic:21748 Well this is a major screw-up , the wireing harness that goes to the Z-axis end stop is 10 cm to short . I have lots of breadboard jumpers so i just used 3 x 10cm ones I had on hand but not everyone has these . The build platform c...
- Sat Oct 07, 2017 10:48 am
- Forum: Mods And Hacks
- Topic: Protect your Board .
- Replies: 1
- Views: 5663
- Fri May 13, 2016 11:36 pm
- Forum: Firmware
- Topic: X-axis problem Prusa I3
- Replies: 10
- Views: 21587
Re: X-axis problem Prusa I3
what kind of wiring are you using ? If you are using that Dupont connector type of connector on the end that could be the problem as there not very secure and if one contact is bad it could cause intermittent contact problems .
- Sat May 07, 2016 12:04 pm
- Forum: Firmware
- Topic: Changing Thred rod
- Replies: 3
- Views: 6598
- Thu May 05, 2016 1:02 am
- Forum: Others
- Topic: My Second M201 has problems
- Replies: 4
- Views: 7836
Re: My Second M201 has problems
These may stop that
http://www.watterott.com/en/SilentStepStick-Protector
http://www.watterott.com/en/SilentStepStick-Protector
- Sun Apr 24, 2016 5:20 am
- Forum: Others
- Topic: DRV8825 missing microsteps ? very interesting article
- Replies: 0
- Views: 3723
DRV8825 missing microsteps ? very interesting article
http://cabristor.blogspot.ca/2015/02/dr ... steps.html
And the results are impressive for such a easy installation .
And the results are impressive for such a easy installation .