Search found 3 matches
Search found 3 matches • Page 1 of 1
Hi,Joe 1.Baud Rate About the baud rate,you should use 250000,which is compatible with the value in the firmware. I used the printer yesterday with the 250000 setting and it worked, so I figured that was find, I just wanted to be sure I would not seen adverse effects. 2.Not In The Center Of Heat Bed...
I seem to me late to this party, sorry for my delay. I can confirm that the new firmware that is posted above does fix the light controls. It would be nice if the brightness could adjusted with the jog dial, kind of like the way you do with you extruder/bed temp. I also noticed that the serial baud ...
- Sun Mar 27, 2016 1:25 pm
- Forum: Others
- Topic: X-Axis Belt Comes Loose From Belt Bracket
- Replies: 5
- Views: 3661
I am encountering the same issue. I agree it looks to be heat related. I am looking at modifying my bracket to 'pin' the belt in place. When I get around to it I will design a new bracket though I would need a new belt to use it.