Geeetech

Printer Prusa I3 Pro. The display worked fine when the print started, and it was fine at the 8 hour mark The current print is a 22hour long print that I am currently 10 hours into. The printer is still printing correctly https://scontent-atl3-1.xx.fbcdn.net/hphotos-xpl1/t31.0-8/12418900_101534947900...

My Prusa I3 Pro has started to do this same thing. The display is all scrambled. Currently I am 10 hours into a 22hour print

Mark wrote:you need to change the DIR of X axis,not the one for endstops....

thanks for the wonderful explanation

So today during my third print I noticed m a grunt sound coming from my heat bed. I stopped the print and began inspecting parts. I found by heat bed belt tensioner with all kinds of metal dust under it. I took it off and found a lot of problems: 1. The belt tensioner position is maybe 10mm off cent...

So the wires that go to the hot end hang down lower than the actual nozzle. With the current carriage there is no way to get them higher. Thusly they drag through my prints and mess them up. Any fix to this?

I have the problem of my x-axis going to the left away from the end stop when using auto home. i tried a fix from above here are my results: 1. this is the original make the x-axis home reversed // The pullups are needed if you directly connect a mechanical endswitch between the signal and ground pi...

I have the problem of my x-axis going to the left away from the end stop when using auto home. i tried a fix from above here are my results: 1. this is the original make the x-axis home reversed // The pullups are needed if you directly connect a mechanical endswitch between the signal and ground pi...