Geeetech

Hello, I'm not sure if my last reply went through or not, but it's been a few days, so I'll reply again. I did test to see if there is a short on the extruder motor pins and on the main board as you asked. As a stepper motor has two coils, each coil had a small resistance indicating that it was a go...

Hello, I have a Prusa I3 X The extruder motor does not move, even without filament. I confirmed that the motor is working by plugging in the Extruder motor to the Y axis port and sending it commands through Repetier and through the LCD move controls. I also confirmed that the motor driver works by s...