Search found 5 matches

by cpt1nsano
Thu Sep 24, 2015 12:05 pm
Forum: LCD Panel
Topic: LCD 2004 Panel Only Showing Blocks
Replies: 33
Views: 28816

Re: LCD 2004 Panel Only Showing Blocks

Got it fixed. Compiled my Marlin1.1 code with Arduino 1.6.5 and then uploaded with AVRDUDE from 1.0.1. Everything works fine now. Just wish I could upload direct from 1.6.5 some problem with bootloader mismatches I think. Not going to worry though. Going to upgrade to a Ramps 1.4 anyway. Thanks for ...
by cpt1nsano
Wed Sep 23, 2015 6:32 am
Forum: LCD Panel
Topic: LCD 2004 Panel Only Showing Blocks
Replies: 33
Views: 28816

Re: LCD 2004 Panel Only Showing Blocks

Thanks, did that already though. Problem is that instead of the display working, the hot bed heater and it's LED start turning on and off in a 0.1 second cycle.
by cpt1nsano
Tue Sep 22, 2015 7:05 pm
Forum: Products FAQ
Topic: Bed Heater Flashing
Replies: 2
Views: 1783

Re: Bed Heater Flashing

1 - Printer works fine with display disabled. 2 - Uncomment: //#define REPRAP_DISCOUNT_SMART_CONTROLLER in configuration.h 3 - Recompile and flash the printer 4 - after upload (or reboot) the hot bed heater (and indicator LED) begins turning on and off repeatedly in a 0.1 second cycle. 5 - This will...
by cpt1nsano
Tue Sep 22, 2015 11:50 am
Forum: Products FAQ
Topic: Bed Heater Flashing
Replies: 2
Views: 1783

Bed Heater Flashing

Hello, I have an Aluminum i3 Prusa. W/ Sanguinololu 1.3a & LCD2004 . It was working fine but I wanted to 'tweek' it. Reflashed the firmware and if I enable the LCD, the bead heater starts pulsing. (everything else works but I can't enable the display, otherwise the hotbed goes nuts.) I gather this m...
by cpt1nsano
Mon Sep 21, 2015 10:17 pm
Forum: LCD Panel
Topic: LCD 2004 Panel Only Showing Blocks
Replies: 33
Views: 28816

Re: LCD 2004 Panel Only Showing Blocks

I too have a wacky display. Was fine until I updated may Sanguinololu with Marlin 1.1. Now printer is fine but display is 'blocked'. I suspect there is a problem in pins.h. Any help? I have the Aluminum Prusa i3 with the 2004 display. Maybe somebody could post the stock factory configuration files? ...