Geeetech

Hello is it possible for you to link or provide printable parts for prusa i3 pro C printer (dual extruder version)? I would like to print spares, because it seems that some of my plastic parts are breaking apart. thank you in advance for your answer. (tried to search the forums but didn't find a thr...

Hello I have not had any luck in solving my problem with the prusa i3 pro C not starting up. Friend suggested to use the bootloader method in uploading the firmware. Is this type of uploading possible? And if yes are there schematics for the GT2560 board how to connect wires for the bootloader method?

Hello 1.) I have tried now to unplug every wire except the USB -> It still times out when I press upload. If I however choose a programmer AVR ISP and then select upload using programmer it will return with a following error: avrdude: stk500_getsync(): not in sync: resp=0x00 attachment: should I use...

I can install a USB Serial port driver using that instructions but with that driver installed it always times out in the "uploading" phase of the process. I will attach a txt file with the error messages that arduino 1.0.1 shows after the process is finally terminated. If I on the other hand try to ...

Hello I contacted your tech support and they pointed me already to that direction. Right now my problem is that I cannot seem to upload firmware or to get arduino working with the printer at all. When I manually install the correct drivers you had mentioned in the thread windows displays it as a mal...

Hello My prusa i3 pro C has stopped starting up. LCD panel shows only two rows of black bars and the reset button doesn't work. - I have tried to connect to the printer via repetetier and octoprint - I have tried to turn it off and on again :) - LCD panel shows only two black bars - I have tried to ...

Hello I have a problem with prusa i3 pro C dual extruder printer. I have to execute M502 command at every start up to start filament to feed, If I wont run that M502 (reset to factory defaults) extruder feeds filament about ten times less than needed (basically none) I have tested with repetetier an...

Hello Posting a reply because I have just the same problem with my prusa i3 pro C dual extruder version (I believe that's also Mk8, even though I only have one fan and website lists that extruder with two fans) So basically extruder randomly jams (probably in the throat section) and starts to either...

Hello I managed to find a good solution by applying extruder offset settings via setting g-code strings to the printer. You can sen g-code lines to printer with repetetier host. 1. send command "M218" -> it will return your current extruder offsets and using that information you can calculate your n...

Hello Here's a picture attached showing the slight misalignment. It's most visible in the wipe tower highlighted in red. X axis has about 0.7mm and Y axis about 0.5mm I don't remember the exact measurements right now. And it seems that setting extruder offsets either in Cura or Repetetier won't have...