Geeetech

My heatbed suddenly stopped working. I bought a new one and installed it and it does not work either. I do not see anything obvious and have checked all wires. I was going to try to flash firmware again just to try it, but I cannot figure out how to do that either. Please help me get the heat bed wo...

I have been able to print now, I figured it out, but the second extruder heats and will not extrude. I was sent an email from Melody at geeetech and told to flash the firmware. I am now trying to figure out how to do that. Supposedly that might fix the second extruder?

I bought the kit for acrylic i3 pro c. I have some of the same issues. The second extruder does not respond to repetier host. It does heat. I have checked the a4988 drivers and switching them with another makes no difference. The driver works when driving a different axis. I also tried plugging extr...

I got my a4988 today and all axis are working. I can control them. The heat bed is not getting up to temp. and I have tried printing with both heat bed on and off. the extruder gets up to temp, I can control it in repetier, but it will not print. When I click to start print it just says print is fin...

Yeah, found the above posts lastnight and a driver board is bad. The printer is brand new. Bought off eBay. It sucks that it had expedited shipping but now have to wait for epacket shipping for the replacement driver to actually be able to print. The instruction had several mistakes too! Including t...

My x axis motor is humming and moves a little. then after a few seconds it moves a little faster but a short distance then stops before hitting the end stop. the other axis y and z are fine. I have tried making sure all the end caps have a good connection. It is still barely moving.

I have printer assembled. It is a geeetech pro c. everything seems to work, except the x axis. It acts like it is stuck for a few seconds and then it moves about an inch then stops before hitting the end stop. All of the end stops work. I can connect to repetier host. in repetier host I can move the...