Search found 6 matches

by walter74
Sat Aug 29, 2015 1:22 am
Forum: Control Board
Topic: Compiling Problems for Rostock G2S
Replies: 4
Views: 6058

Compiling Problems for Rostock G2S

Hi, In early August 2015 I could drag the necessary files into an Arduino 1.0.5 sketch as described in the Building Instructions but when I tried to compile there were all sorts of Errors including the problem with time.h not being in any Library. Recently I I tried to use Arduino 1.6.5 with no impr...
by walter74
Sat Aug 29, 2015 12:57 am
Forum: Control Board
Topic: MicroStepping up & down on Rostock G2S
Replies: 0
Views: 1785

MicroStepping up & down on Rostock G2S

Hi, Having finally worked out that, when the LCD was plugged in I could not Upload the firmware, Having managed to upload, when I turn the power on all 3 motors do one microstep up, then down, then up, etc until I turn the power off. Repetier Host will not control the motors & I get the following re...
by walter74
Sat Aug 29, 2015 12:27 am
Forum: LCD Panel
Topic: FAQ
Replies: 2
Views: 5506

Re: FAQ

Hi, I have got the problem described in Issue 3:2. I have bought the Rostock mini G2S with GT2560. 1) If the LCD is connected to the PCB then the Arduino IDE cannot upload the Firmware, even the latest; 2) I can Upload with the LCD unconnected and, when I turn the power on X, Y & Z motors do 1 micro...
by walter74
Tue Jul 14, 2015 1:33 pm
Forum: Software
Topic: G-Code will not manually move Delta Rostock G2S
Replies: 5
Views: 3975

Re: G-Code will not manually move Delta Rostock G2S

Thank you for the link to the file. However the Delta Rostock G2S has 2 Extruders. Do I ignore the title " Single Extruder " ?
by walter74
Mon Jul 13, 2015 8:05 pm
Forum: Software
Topic: G-Code will not manually move Delta Rostock G2S
Replies: 5
Views: 3975

Re: G-Code will not manually move Delta Rostock G2S

Hi, I have stopped and started the printer a few times with no success. I am trying to calibrate the machine so there is no filament in the HotEnds, the HotEnds are not heating & their Fan is not working. The 2 Extruder Fans & the Fan for the Electronics board are working. When the Printer is switch...
by walter74
Fri Jul 10, 2015 11:16 pm
Forum: Software
Topic: G-Code will not manually move Delta Rostock G2S
Replies: 5
Views: 3975

G-Code will not manually move Delta Rostock G2S

Hi, I have assembled the 3D Printer & am " Printer Preparing " at step 2 of section 2 to measure the distance between the nozzle & print surface. When I put in the G-Code 'G0 X0 Y50 Z2' there is no movement of the print head after pressing 'Send'. Between 'Manual Control' tab & the "G-Code" line it ...