Geeetech

I added 3d touch sensor to my I3X printer.Its wors .But one major problem is the hot end level and 3d touch needle level is same. When print start sensor removing print.pls tell me how to fix this?

I added 3d touch sensor to my I3X printer.Its wors .But one major problem is the hot end level and 3d touch needle level is same. When print start sensor removing print.pls tell me how to fix this?

Hi My noozzel hot end point and 3d touch sensor point is same level.So when noozel prints sensor will remove.How to fix this please anybody letme know. Thanks advance <blockquote class="imgur-embed-pub" lang="en" data-id="a/KHtxG"><a href="//imgur.com/KHtxG"></a></blockquote><script async src="//s.i...

I fixed it,the third pin not solder proper.i re solder that.now its working.thanks

Hi
I have check voltage as shown in your link.It shows 5.3volt and 11.9 volt.I think some other problem.

Hi
I replaced Stepper drive for my I3ProX.My all stepper motors getting too much heat about 70c if I run continue 45 minutes .I cant touch that.What is problem how to correct it?
If it is problem of current(I am using A4988) how to adjust and what current output should go to each stepper?
Thanks
Shiva

Hi
I replaced Stepper drive for my I3ProX.My all stepper motors getting too much heat about 70c if I run continue 45 minutes .I cant touch that.What is problem how to correct it?
If it is problem of current(I am using A4988) how to adjust and what current output should go to each stepper?

Ya,I soldered backside also .I made small hole and through hole i put the pin and soldered.Please tell me how to check it properly sold?any particular signal or current will come?

Hi Ajey
pls check attached image in 1st image i soldered 3rd pin.In second picture wiring.I onneted Black-Brown,Green-Orange,Blue-Red and in 2 pin section connected Blue-Black and Red-White.

hi,
I am using I3 pro X.I soldered 3rd pin as per instruction and also updated frimware.When i connected sensor not working.Pls some body help me.Pls let me know how to test 3rd pin properly placed or soldered?
Thanks in advance
Shiva