Geeetech

Ok, so the fan works now, or just turns on.

I can not get the extruder to a temperature above 220 degrees. As such I can not print with it - WHY WILL IT NOT GO HOT ENOUGH TO DO ANYTHING WITH!!!!

PROVIDE SUPPORT OR I WILL REQUEST A REFUND

please advise

Well the fan is where it came pre-mounted, having said that it is not wired as you provided a fan with a 2 pin fan knowing I have a 3 pin controller. So I have now tried the other extruder I purchased to see if I had a bad one and get the same results. Please advise or replace the two extruder assme...

I can not get the temp to go passed 215, Do you think we have a bad extruder?

Please advise

Ok,

That said it looks like I can not get the extruder to extrude filament then. It goes through the stepper motor ok but will not extrude. I cannot even force push the filament into the head it seems to either be blocked or not hot enough to melt the filament.

Please advise,

Jason

I purchased the -Assembled JIETAI GT9L Extruder- and would like to switch out the stock extruder on my prusa I3. Would you please give me the firmware update that I would need for it?

I have this control board GT2560 3D printer controller board.

Thanks

How do I utilize the LCD 12864 with the GT2560 Controller?

Currently I am using the standard LCD,

In the technical specs it lists the ability to use both monitors.

Please advise

Loading via the lower version seemed to work,

I also have a problem with the slicer

I attached a photo of the issue

Please advise

1.6.4

All of the files are loaded into audrinio, 73 total

I got the error while trying to upload the firmware>

I loaded the .ino file into the software and clicked upload. (I think there was a total of 73 files that loaded in the Arudiono for the upload